Week 2 · Vital Signs in Motion

Blood Pressure & Heart Rate During Exercise

Last week the client sat still. This week they walk on a treadmill while you take vitals at the end of each stage, the same skill used in every clinical graded exercise test.

Pre-lab ≈ 45 minIn-lab 75 minNotebook ≈ 60 minTools: treadmill, BP cuff, stethoscope, HR monitor

Overview

During dynamic exercise, cardiac output rises to deliver oxygen to working muscle. Heart rate and systolic pressure climb together with workload, while diastolic pressure stays about the same or falls slightly because the arterioles in active muscle dilate. Knowing this "normal" pattern is what lets you spot an abnormal one, and an abnormal BP response is one of the clearest reasons to stop a test.

Learning objectives

  1. Set up and operate a treadmill safely, including the emergency stop and safety clip.
  2. Measure HR and BP in the last 30 s of each 3-minute stage during walking exercise.
  3. Calculate the oxygen cost of each stage with the ACSM walking equation and express it in METs.
  4. Graph the HR and BP response and compare it with the expected exercise response.
  5. Recognize the BP responses that are criteria for stopping an exercise test.
ComponentWhat you doTime
Pre-lab readingBackground, interactive tool and one research article≈ 25 min
Pre-lab quiz (5 pts)8-question checkpoint (2 pts) and 3 discussion questions (3 pts)≈ 20 min
Lab activityResting vitals, then a 5-stage walking protocol with vitals each stage and a 5-minute recovery (2 clients per treadmill)75 min
Lab notebook (15 pts)Stage table with ACSM VO₂ and METs, HR/BP response figure, discussion≈ 60 min

Pre-Lab Reading ≈ 25 min

Every pre-lab has the same three parts: background reading, one article from the research literature, and the pre-lab quiz and discussion questions you submit before lab.

1. Why heart rate rises

At the start of exercise, the brain's motor command and feedback from muscle receptors reduce parasympathetic (vagal) tone, so HR rises within seconds. As intensity increases, sympathetic drive adds to it. In steady-state submaximal exercise HR rises roughly linearly with VO₂, which is why HR can be used to estimate fitness and to set training intensity. It levels off at a steady state in about 2–3 minutes at a constant workload, which is why our stages last 3 minutes and we measure at the end of each.

2. Why systolic rises and diastolic does not

Mean arterial pressure equals cardiac output × total peripheral resistance. In dynamic exercise, cardiac output may rise four- or five-fold, but the vessels in working muscle dilate and resistance falls. The net result:

  • Systolic BP rises about 8–12 mmHg per MET and may reach 160–220 mmHg at maximal effort.
  • Diastolic BP stays within about ±10 mmHg of resting, or falls slightly.
  • In recovery, SBP often dips below resting for an hour or more (post-exercise hypotension).

3. Abnormal responses: when to stop

FindingWhy it matters
SBP drops more than 10 mmHg from baseline or the previous stage despite a higher workloadThe heart may not be able to raise cardiac output (possible ischemia or left ventricular dysfunction)
SBP > 250 mmHg or DBP > 115 mmHgHypertensive response; excessive cardiac and vascular stress
Chest pain, dizziness, confusion, pallor, cyanosis, ataxiaSigns of poor perfusion
Client asks to stop, or the equipment failsAlways a stop criterion

4. Estimating the oxygen cost of walking

VO₂ = 0.1·S + 1.8·S·G + 3.5ACSM walking equation, mL·kg⁻¹·min⁻¹ (valid ≈ 1.9–3.7 mph)
S (m/min) = mph × 26.8Speed conversion; 2 mph = 53.6 m/min
G = % grade ÷ 1007.5% grade → 0.075
METs = VO₂ ÷ 3.51 MET = resting oxygen uptake

Interactive: The exercise response curve

Our exact lab protocol, simulated. Change the fitness level and resting values, then switch the BP response to "exaggerated" or "exertional hypotension" and see which stop criteria the table flags.

5. Practical challenges

Measuring BP on a moving person is harder: the arm swings, the belt is noisy, and the cuff tubing knocks against the stethoscope. The client should rest the measured arm on your shoulder or on a support, relaxed, at heart level, while holding the handrail lightly with the other hand. Start the measurement at 2:30 of each 3-minute stage so you finish before the stage changes, and leave the cuff on for the whole test.

6. Watch before lab

Watch this short video on setting up a submaximal treadmill test. Notice that the BP cuff stays on for the whole test.

7. From the literature ≈ 15 min

Read this week

Kim, D., & Ha, J.-W. (2016). Hypertensive response to exercise: Mechanisms and clinical implication. Clinical Hypertension, 22, 17. pmc.ncbi.nlm.nih.gov/articles/PMC4962449/

Today you watch SBP rise stage by stage. This short review (four pages) explains why some people's SBP rises too much, and why that matters even when their resting BP is normal.

Read for:

  1. How the authors describe a hypertensive response to exercise (HRE), and whether there is an agreed cut-off.
  2. The mechanisms they propose (blood vessels, nervous system, hormones).
  3. Why an HRE may matter for someone whose resting BP is normal.

Before you come to lab

  • Wear athletic shoes and clothes you can walk in; short sleeves for the cuff.
  • Avoid caffeine and nicotine for 30 minutes and hard exercise on the day of lab.
  • Review the five-stage protocol and the stop criteria table so you can act quickly.

Pre-Lab Quiz ≈ 20 min

Two parts, both due before lab (5 pts). Checkpoint (2 pts): eight questions on the background and the article; aim for 7 of 8 before you come to lab. Discussion (3 pts): three short written answers you submit to your course site.

Checkpoint

During a normal graded walking test, diastolic BP should:
Vasodilation in active muscle lowers peripheral resistance, so DBP changes little.
What is the ACSM walking VO₂ at 2 mph and 5% grade?
S = 53.6 m/min. 0.1(53.6) + 1.8(53.6)(0.05) + 3.5 = 5.36 + 4.82 + 3.5 = 13.7 mL·kg⁻¹·min⁻¹ (≈ 3.9 METs).
Your client's SBP goes from 148 mmHg at 5% to 132 mmHg at 7.5%. You should:
A drop of more than 10 mmHg with rising workload is a termination criterion.
Why are stages 3 minutes long?
Measuring at the end of each stage captures steady-state values.
Which change drives the rise in HR in the first few seconds of exercise?
Vagal withdrawal acts within a beat or two; sympathetic and hormonal effects follow.
Kim and Ha (2016) report that the SBP value that defines a hypertensive response to exercise:
Different studies use different thresholds, which is one reason the finding is hard to act on.
Which mechanism do Kim and Ha (2016) link to an exaggerated BP response?
Arteries that cannot dilate well or are stiff raise pressure more for the same rise in cardiac output.
During a graded walking test, mean arterial pressure rises mainly because:
MAP = cardiac output × TPR. Cardiac output rises several-fold while TPR falls only partly, so MAP and SBP rise.

Discussion questions (submit to your course site)

About 75–150 words each unless stated. Each answer is worth 1 point: correct physiology, specific to this lab, and in your own words. Cite the article (author, year) wherever you use it.

1. Why is it important to monitor heart rate and blood pressure during exercise? Give one physiological reason for each.

2. What makes measuring BP on a moving treadmill difficult, and what will your group do today to get reliable readings?

3. Using Kim and Ha (2016), explain why an exaggerated SBP rise in a client with normal resting BP is worth noting and referring, even though there is no agreed cut-off.

Lab Activity 75 min

Roles (groups of 4)

  • Participant walks the protocol.
  • Technician takes BP and HR (radial pulse, confirmed by HR monitor).
  • Data collector runs the stage clock, calls "2:30," records.
  • Safety monitor stands behind the treadmill, watches the client, controls the emergency stop.

The protocol takes about 25 minutes, so each treadmill tests 2 participants. Rotate so everyone takes at least one full set of exercise vitals.

Equipment per group

  • Treadmill with emergency stop and safety clip
  • Sphygmomanometer and stethoscope (cuff stays on)
  • Chest-strap HR monitor (to check palpated HR)
  • Stopwatch; data sheet; PAR-Q+ for each participant
  • Chair beside the treadmill for seated rest and recovery

Timeline

  • 0:00–0:08Treadmill orientation: emergency stop, safety clip, straddling the belt, stepping on and off. Assign roles.
  • 0:08–0:38Participant 1: 5 min seated rest + resting vitals, 14-min protocol, 2-min cool-down, 5-min seated recovery.
  • 0:38–1:08Participant 2, rotating roles.
  • 1:08–1:15Calculate VO₂ and METs for each stage on the data sheet; clean equipment.

Protocol

StageSpeedGradeDurationStart vitals at
Rest (seated)——5 min4:00
Warm-up2.0 mph0%5 min4:30
Stage 12.0 mph2.5%3 min2:30
Stage 22.0 mph5%3 min2:30
Stage 32.0 mph7.5%3 min2:30
Cool-down1.5 mph1%2 min—
Recovery (seated)——5 min4:30
  1. Take resting HR and BP after 5 minutes seated. Do not start if resting BP is above 200/110 mmHg.
  2. Clip the safety key to the participant. With the participant straddling the belt, start it at 2 mph, then have them step on.
  3. At each "start vitals" time, the participant rests the cuffed arm on the technician's shoulder. Take BP, then a 15-s radial count × 4 (record the monitor's HR too).
  4. Change the grade exactly at the end of each stage, even if a reading is still in progress; note any late reading.
  5. After stage 3, reduce to 1.5 mph and 1% for 2 minutes, then stop and seat the participant. Take recovery vitals at 5 minutes.
📍 Set up for your campusTwo participants per treadmill fit in 75 minutes. With fewer treadmills, run the same idea on cycle ergometers (3-minute stages at 25, 50, 75 and 100 W; ACSM leg-cycling VO₂ = 1.8 × work rate (kg·m/min) ÷ body mass + 7), or test one participant per group and have the others practise exercise BP on a partner pedalling.
SafetyKeep the area behind the treadmill clear. Stop the test for any criterion in the pre-lab table, or if the participant asks. This is a light-to-moderate test; do not change the protocol to push to maximal effort.

Lab Notebook ≈ 60 min · due at the start of next lab

Step 1 — Stage calculations ≈ 15 min

With speed (mph) in B and grade (%) in C:

  • VO₂: =IF(B2=0,3.5,0.1*(B2*26.8)+1.8*(B2*26.8)*(C2/100)+3.5)
  • METs: =H2/3.5 · %HRmax: =D2/(220-age)*100
  • Change from rest: =F3-F$2 for SBP and DBP.

Step 2 — Figure 1: the exercise response ≈ 20 min

Line chart with stage on the x-axis (Rest, Warm-up, 2.5%, 5%, 7.5%, Recovery), SBP and DBP on the primary axis (mmHg) and HR on the secondary axis (bpm). Number and title the figure, label axes with units, include a legend. Optional Figure 2: SBP vs METs with a linear trendline; the slope is your client's mmHg/MET.

Step 3 — Discussion ≈ 25 min

  1. What were your participant's HR and BP classifications at rest?
  2. Using Figure 1, did HR, SBP and DBP follow the expected exercise response? Explain why or why not, citing the physiology.
  3. What was the participant's SBP rise per MET? How does it compare with the expected 8–12 mmHg/MET?
  4. How closely did palpated HR agree with the HR monitor? What could explain the difference?
  5. What could have affected your results, and did you feel comfortable collecting vitals during exercise? Why or why not?

Grading rubric (15 pts)

CriterionPtsFull credit looks like
Data & calculations4All stages recorded; VO₂, METs, %HRmax by formula
Figure 14HR and BP vs stage, secondary axis, units, numbered caption
Discussion6Every question answered with data and correct physiology
Presentation1Clear, complete sentences, consistent units